| |
 |
 |
 |
|
Radio Bezel |
May 16, 2015 |
| Reviewer:
Rick McGuire from Redmond, WA United States
|
|
I like this product, but it requires more prep work. you have to take the air vents from an OE bezel and glue them in. I used epoxy putty found at most Hobby stores to replicate the heat stakes on the original. You will also have to operate on the air vents you will need to take out the open close wheels to get the vents to fit, directions are on the site. It gives a different styling look. You will also have to transfer over the retaining clips, a pair of pliers works well. The bezel does not come with the 6 rubber tipped feet but it doesn't need them, carbon fiber is much stiffer than plastic. If the bezel sits lower into the dash than you would like you can put some washers behind the HVAC controls to move it out.
Was this review helpful to you? 
|
|
 |
|
 |
|
Ford Mustang